Was the first man made machine to travel at 100mph..?

Was it the City of Truro locomotive on a west country rail line in early 1904, where the engine driver and the fireman lost temporary control of their steam engine . Was the pressure realease valve stuck? Can anyone varify this?

Answers:
City of Truro certainly travelled very fast down Wellington Bank in 1904 but the timers only clocked 102 mph over one1/4 mile before the driver spotted men working on the track and braked, there is little doubt that a higher speed could have been reached had this not happened. City of Truro ran on to Bristol as planned where Duke of Connaught, a 4-2-2 ran the train on to london also at record speed. The engine change was required because there were no water troughs at this time and the 3500 gallons in the tenders was only sufficient for Plymouth to Bristol, it was much quicker to change engines than refill tenders.
The speed was certainly not accidental as enthusiast train timers were invited to be aboard. Several other City class engines had previously travelled very fast down the Bank so the GWR probably thought itself on safe ground when it decided to go for the Ton. It is very likely that Saint class engines were being run up to even higher speeds at around this time on light engine trial runs from Swindon Works especially down Dauntsey Incline some 10 or so miles west of Swindon.
It was the airplane!!
i think so.
It looks like it was the City Of Truro in 1904 but was not a pressure valve issue. It was done deliberately on a short downhill section near Taunton - here's a link http://en.wikipedia.org/wiki/gwr_3440_ci. and another http://www.swindonweb.com/guid/cityoftru.
It was the City of Truro, though couldn't verify the pressure release valve problem.

The answers post by the user, for information only, UKQnA.com does not guarantee the right.

  • Any advice would be helpful!?
  • is BP ultimate petrol really better for the engine than ordinary unleaded, please?
  • Self build motor homes.?
  • does any one know the market value of a rover 214 sli k reg 116,000 miles?
  • What would you do if you got sucked inot a jet engine?
  • major clutch adjustment on yamaha DT125 Also is there a ball bearing between the actuating rods?
  • i used to like tractor's does that make a extractor fan?
  • Someone has crashed into my car and drove off.?
  • Why are you told to close the blinds on a plane aduring a night flight??