Pug 106 leaking water?
Answers:
Most likely as both previous answers have said It'll be a heater hose, you should have two hoses going into the car from the engine bay, they should be very easy to spot(about 1 inch diameter) and probably both at the same place, check these.
Fix/Replace these sooner rather than later or you will cook the engine!
when topping up use a 50/50 mix of antifreeze/water this will protect your car down to -32C.
sorry can't give you specifics I've not touched a pug cooling system before.
good luck!
a heater hose has bust
A hose is either crack or come loose.
Climb up under there and take a look, it might just need pushing back on, and the screw tightening on the clip.
if its a petrol engine, check under the inlet manifold there is a hose going onto a small metal pipe. The metal pipe corrodes, where it goes into the manifold.
if its not a bad leak top up coolent and put a egg in this worked for me for 2years but then crashed car
The answers post by the user, for information only, UKQnA.com does not guarantee the right.