Car bodyfiller?

would i be able to use this 2 extend my back cossie arches such as fitting them 2 my car then aplying body filler then smoothing into shape or aplying the filler 2 my car get a layer then fitting the arches to the filler thx sean

Answers:
If your only 17 you will be too young to buy car body filler because it is a solvent.
Solvent abuse can kill.
Please use spell check before posting little boy.
WHY ?
get a grip on reality.your cossie is not worth the hassle
use chewing gum
worth a try but if its a big area it may fall out going over a bump as theirs no give in it, try fiberglass, more plyable and alot stronger, good luck mate, dont listen to others you have a classic nice car !!!
what cossie have you got? cos they dont have back arches?.but on such a car do it properly, at those speeds it will just fall off !!
If you just use filler, it will fall out.

If you really want to make this, mod, get an old biscuit tin and with tin snips and pliers, rough it into the shape you want to extend.

Temporary fit it into place with screws.

Use fibre glass and resin to make the permenant fixture. Remove screws - if possible.

Then use the filler to make up the shape.

Finally, use cellulose putty to make the final skin.
use Gripfil
comes in a green and black tube buy from builders merchants ie jewsons..
clamp the arches in place-pre drill holes for pop rivets-apply two pack epoxy glue (try and get a two into one squeezy gun less mess ) swiftly rivet the arch in place - fibre glass bridging filler a rough shape (sand smooth)-filler a good shape then smooth -stopper for final skim/removal of pin holes - filler primer- easy ..one tip-dont bake the top coat-all trapped air will blow through the surface and ruin youre hard work
The filler is OK .. it's just a FORD
No do not use just body filler ! This will crack the first time you take the car on the road ! you need to buy some "stickflex" bonding sealant ( similar stuff they use to put wind screen`s in with ) this will allow movement in the bodykitt you are trying to fit . Very messy job though you will need rubber gloves for this cause it`s a bastard to get off your finger`s afterwards . email me for futher info if you need it .. good luck .

The answers post by the user, for information only, UKQnA.com does not guarantee the right.

  • why are 4wd's known as 4x4's?
  • Whats the best sat nav to buy and can you get the speed camera locations on it?
  • back seat drivers do they do your head in?
  • wide bodykits?
  • daf 95 or volvo fh which is better?
  • peugeot 406 2.1 td throttle problems ?? has anybody else had any trouble with the engine not revving ?
  • Where is the motor for the screen washer?
  • What % of London underground workers are on a sickie at any one time?
  • how big would a ship have to be to make the sea level rise to say 1meter?