Pug 306 starting problems?

i did the head gasket on my 306 and now it wont start up

Answers:
Have you repositioned the cam shaft sensor correctly afterwards?

If it's out of range or too close then it won't let the engine turn.
aha.

.many things to work through.

.are the plugs connected in the correct order for a start.?
first as the venerable jedi says (hello master fancy seeing you here, looking well!) check the plug leads have been put on the correct plugs.

sounds to me like you have probably moved or unsettled a piston ring and this is causing the compression gasses past the piston causing the feeling of no compression. if you can get a compression tester then do so and check. bad news being you may have to whip the head off again and re assemble making sure you havnt altered the valve timing.

The answers post by the user, for information only, UKQnA.com does not guarantee the right.

  • Do you Know where I can buy and how much it cost Fuel Level Sensor for Rover 214 Si from 1997?
  • I have a gsxr750g and need a new rear shock wil 1 off a later model fit & if so which model?
  • is the road a563 attlee way a dual carriageway ?
  • How do I check & top-up the auto gearbox oil level on a 1994 BMW 325 td??
  • How long does it take DVLC to turn round a change of address licience?
  • what is a nautical knot in mph?
  • what is the Climb rate of the Hunter Mk 2 and 6 and onwoods?
  • where can i ride my moto x off roadnear to manchester england?
  • where can i find the wiring diagram for a fiat punto 55 Lreg.ive bought a car stereo and im confused, thanx?