Just bought a car and I have to brake hard to get car to stop is this because the break pads need changing?
Answers:
It is probably the brake pads, but try checking the brake fluid first. It may be this, and it is cheaper than changing the brake pads for no reason.
SOUND'S LIKE IT
Brakes are hardly something you want to tinker with if you don't know what you're doing. If you're asking that question, then don't even think of fixing it yourself.
Take it in to a good garage and the mechanic will tell you what needs done.
Could be brake pads,bad master cylinder, air in brake lines. get it fixed before you kill yourself or somebody else.
Could easily be the servo.
it depends. if its brand new take it to the dealer. if its used, the power brakes may be failing, or the brake pads or shoes or rotors. all depends, take it to a mechanic though
Yes it sound like you need new brake pads or maybe you have dust on the brakes either way you need to get it check at a garage
more like the brakes need bleeding, if there is an air lock in the system the brakes feel spongy and the brake pedal travels right down when you press it before it begins to break, take it back to the garage you bought it from or if you bought private get it checked at a garage, some offer a free break check, worth a look anyway.
air in brake system,
The brakes can act like that if the brakes are leaking or your fluid level is low or your disks are worn or there is air in the system or the calipers are sticking or the pads/shoes are worn. there are many reasons best get it checked out as soon as possible
It's a possibility. Usually, when pads are worn, you hear a grating noise, maybe feel some vibration, maybe uneven braking such as steering wheel pulling left or right.
With power assisted brakes, you may have a problem with the hydraulics, such as low on fluid, spill over in the master cylinder, brake cylinders at one or more wheels sticking or not working.
You don't say what kind of car, age, or what you used before. It may be just a different feel from one vehicle to the next.
Because brakes are the most important safety feature in your vehicle, have them checked by a pro. Your brakes may fail and you may run into me.
All these answers could be true. Just do the sensible thing and take it to the garage to get professional fix.
Some times if the break pads have been changed very recently and there is some wear in the discs, the breaking can be hard until the pads wear in to the exact shape of the discs that they press against. Usually a couple of hundred miles even. If you have any concern at all, check it out. I always say that the skill of driving is not in how fast one can go. Its how fast you can stop.
excess travel indicates air in the system,by bleeding in a closed system of fluid you can remove this.
Need more information in order to confirm the brake pads are to blame.
Is there excessive travel on the pedal? And does this reduce if the pedal is pumped several times? If this ocurrs it is likely to be air in the brake fluid.
Is there a grinding noise when braking? If so your pads are likely worn.
If you just have to push hard on the pedal then this would point toward the brake servo or the link between the servo and inlet manifold.
It could be worn brake pads, moisture (water) in the hydraulic fluid, leaking calliper piston seals, leaking brake fluid lines, a faulty brake servo. It will be a process of elimination to find the fault, but try the easiest route (less costly, and obvious if the problem!), the worn brake pad check first!
To check your brakes:-
Look at the fluid level, it should be between min -max. if its below then there may be a leak. Check the inside wall of your tyres, if any of the cylinders / calliper's are leaking the tyre will be damp with fluid, check where you normally park your car for wet patches on the ground in case its a small leak on one of the pipes.
If new brake pads are fitted with a harder lining compound this would make the braking harder, but i doubt it is this,
Usually the cause of excessive force needed to brake is down to the brake servo, best to check this first, With engine stopped, push the brake pedal several times, then while pushing the brake pedal down start the engine, you should feel the pedal go soft and move down, if it feels the same as you start the car there is no vacuum in the servo, this could be perished diaphragm in the unit or more often a leak in the pipework, if diesel it has a dedicated vacuum pump, on petrol its a connection on the inlet manifold. AS with any braking problem if your not sure its safe, get someone who knows whats what.
you could have a leaking cylinder take it to a garage as soon as poss
more than likely ya are gonna need new pads..if not check your brake fluid level..if its low..add more..also have your brake booster checked.if that doesnt solve it check your rotors.if it were your pads you would hear a squeaking noise when you applied the brakes.ya might wanna try checking the lines.ya could have caliper problems.could be a lot of things.good luck with it..hope i helped
The answers post by the user, for information only, UKQnA.com does not guarantee the right.