I have recently installed a shark 2 alarm to my citroen ax,at which point do i connect same to indicators?K?
Answers:
I would do it near to the bulb holder as possible. Feed them to the live. (usually yellow or grey) (earths green & yellow) the alarms fused and earthed. If this fails connect them to the earth. (green & yellow) but it is normally live.
would someone really want to pinch a citroen ax
its normal practise to connect al alarm wiring looms internally, behind dash/steering column cowling etc if you remove steering col/cowling and trace wires to indicator switch use 12volt test light and test wires from switch when operating indicators light will flash on two separate wires connect to these.
Do you really believe someone would actually STEAL it?
Hello yes would connect wires as close to dash switches as possible.
you may find that behind the hazard warning switch their is two wires that supply the indicator output for each side of the vehicle one LHS and one RHS.
That would be the simplest place to wire in the feed.
Please rememer always fuse your power supplies, and try not to use scotchloc's, use crimp type connectors if you cant solder the wires on.
The answers post by the user, for information only, UKQnA.com does not guarantee the right.