Deos anyone know were i can get engine diagrams for a dt100 yamaha?

the clutch rod has snapped i think thanks for all the help cheers

Answers:
Clutch rod on a DT100 or a RT100 which is basically the same motor is in two pieces. One part has a mushroom end which pushes the clutch pressure plate, then there is a small ball bearing, then a straight rod, maybe 5 cm long. They all fit inside the gear shaft.
Straight rod goes in first from the clutch end.
check with a yamaha shop they might be able to order you one, igot one for vintage hondas that way

The answers post by the user, for information only, UKQnA.com does not guarantee the right.

  • Does speed or bad driving REALLY kill?
  • cambelt timing on ccm 604 sport?
  • mondeo/contour st200 conversion?
  • I'm looking for a 2nd hand car, which webites besides ebay and autotrader are worth looking at?
  • what does an independent doctors examination involve after a disqualification ends for drink driving?
  • Would you consider downsizing you car?
  • I need to get to nottingham from peterborough tomorrow morning. Should I drive or take the train?
  • what is a coil wire?
  • Why did Kamikaze pilots wear crash helmets?