Info how fit filters too ford puma air oil?
Answers:
ok air filter is easy as it is in a housing that will have clips on it simply unclip the clips remove the old element and clean out the filter housing then fit new. The oil filter is a bit harder i cant remember if it is an element or a canister. If it is a canister it will look like a tin can usually painted red, white, or black, you need a oilf filter wrench or remover to take that off as it is tight, when you slacken it make sure you ahve a container underneath to collect any waste oil that seeps out, remove the old filter and let the oil drain in to the container. Before fitting the new one make sure you clean the filter housing where the filter will screw in to and aldo lubricate the rubber ring on the filter (so it doesnt twist when your tightening it and it wont leak) then tighten the new filter by hand as tight as you can, wipe any excess oil off and thats done.
If its the element type there will be a black plastic housing about the same size and you will need to release this, the filter inside will look like the air filter, simply take the old one out and fit any new seals that come with it replace is revers of removal. Dont forget that you need to be careful of how you dispose of the filters they need to be disposed of corrrectly, and it would be a good idea to change the oil at the same time
get specs, read specs
There are a number of articles about these tasks on our websitem see below ;
The answers post by the user, for information only, UKQnA.com does not guarantee the right.